DewEze Pump 10 gallon per minute, A mount Turolla High Pressure 83012715 Side Port S16mb P12mb. This is the Pump OnlyNOTE TO INSTALLER Clutches will need a short burnishing period to generate the rated torque. This is a process of cycling the clutch to slightly wear the friction surfaces. This allows full contact and maximum magnetic attraction required for rated torque (or more).BURNISHING-TO AVOID BURNING OR HEAT DISTORTION, THE FOLLOWING PROCEDURE IS RECOMMENDED:After clutch is installed, run at 1000-1200 RPM. Cycle the clutch on/off at the rate of 1 seconds on – 1 seconds off for a minimum of 30-40 cycles. Mount: A GPM: 9 Port: Side Shaft: 7/8″ Taper Bolt: 5/16-24×1 Rotation: CW Material: Iron CS Thick: 2-9/16″ Model Number: 83012715 CI: 1.28 Suction H: 1″ Suction F: 16mb Pressure H: 3/4″ Pressure F: 12mb PSI R1: 3000 PSI R2: 4000 Seal Kit: 722084 Shaft Key: 720161 Front Seal: 722083 Series: SD Where It’s Used: 700520, 700521, 700522, 700523, 700526, 700527, 700542, 700543
