DewEze Pump 7GMP Rear Port. A mount Parker P315 326-9110-116 Rear Port S16mb P12mb. Compatible with DewEze Products. This is the Pump OnlyNOTE TO INSTALLER Clutches will need a short burnishing period to generate the rated torque. This is a process of cycling the clutch to slightly wear the friction surfaces. This allows full contact and maximum magnetic attraction required for rated torque (or more).BURNISHING-TO AVOID BURNING OR HEAT DISTORTION, THE FOLLOWING PROCEDURE IS RECOMMENDED:After clutch is installed, run at 1000-1200 RPM. Cycle the clutch on/off at the rate of 1 seconds on – 1 seconds off for a minimum of 30-40 cycles. Model: P315 Port Side: Rear Mount: A Gallons Per Minute: 7 CID: .93 Center Section Thicken: 1-1/8″ Appearance: Gray Cast Clockwise Rotation Model Number: 326-9110-116 7/8″ Tapered shaft with a woodruff keyway Used in the following kits 700001, 700002, 700003, 700004, 700005, 700006, 700007, 700008, 700009, 700010, 700012, 700013, 700014, 700015, 700016, 700017, 700018, 700020, 700025, 700026, 700027, 700030, 700031, 700032, 700034, 700035, 700036, 700038, 700039, 700040, 700041, 700042, 700046, 700063, 700065, 700067, 700068, 700069, 700070, 700071, 700072, 700073, 700074, 700075, 700076, 700078, 700083, 700087, 700088, 700089, 700090, 700091, 700099, 700300, 700318, 700319, 700322, 700323, 700325, 700326, 700341, 700347, 700349, 700362, 700366, 700369, 700371, 700374, 700379, 700382, 700383, 700386, 700387, 700388, 700389, 700401, 700402, 700403, 700404, 700406, 700407, 700413, 700414, 700415, 700417, 700418, 700421, 700422, 700424, 700425, 700426, 700442, 700445, 700449, 700450, 700451, 700452, 700454, 700455, 700456, 700457, 700458, 700460, 700462, 700465, 700466, 700468, 700469, 700495, 700496, 700501<, 700502, 700503, 700505, 700506, 700507, 700511, 700516, 700517, 700518, 700524, 700529, 700535, 700551, 700552
