DewEze AA Parker Hydraulic Pump 0.43ci P505 331-9110-207 Rear Port S10mb P8mb. This is the Pump OnlyNOTE TO INSTALLER Clutches will need a short burnishing period to generate the rated torque. This is a process of cycling the clutch to slightly wear the friction surfaces. This allows full contact and maximum magnetic attraction required for rated torque (or more).BURNISHING-TO AVOID BURNING OR HEAT DISTORTION, THE FOLLOWING PROCEDURE IS RECOMMENDED:After clutch is installed, run at 1000-1200 RPM. Cycle the clutch on/off at the rate of 1 seconds on – 1 seconds off for a minimum of 30-40 cycles. Mount: AA GPM: 2.79 Port: Rear Shaft: 1/2″ Straight Bolt: 1/4-20×3/4 Rotation: CW Material: AL CS Thick: 2″ Model Number: 331-9110-207 CI: .43 Suction H: 5/8″ Suction F: 10mb Pressure H: 1/2″ Pressure F: 8mb PSI R1: 3900 PSI R2: 3900 Seal Kit: N/A Shaft Key: 710918 Thrust Plate: 722036 Series: P505 Where It’s Used: 700077, 700084, 700086, 700095, 700097, 700304, 700309, 700310, 700316, 700320, 700324, 700327, 700331, 700332, 700334, 700335, 700338, 700345, 700346, 700352, 700353, 700359, 700361, 700368, 700370, 700372, 700373, 700375, 700376, 700377, 700380, 700381, 700384, 700399, 700408, 700410, 700432, 700439, 700446, 700453, 700464, 700481, 700499, 700513, 700519, 700566, 700588, 700591, 700593, 700596, 700598, 700602, 700603, 700608
