Buyers Products SaltDogg Cubic Yard Gas Hopper Spreader gives contractors andbusinesses a gas-powered spreader ready for commercial applications using bulksalt, bulk sand, or a 50/50 salt/sand Its. The spreader combines the power of agas engine with modern spreader conveniences. mix. SD-1400350SS 2.5 cu yd 120″ Chute SD-1400100SS 2.0 cu yd 96″ Chute SD-140025SS 1.5 cu yd 72″ Chute Hopper spreaders are completely self-contained, ultra-durable spreader units designed for ice and snow control The rugged design allows for use with salt, sand and other materials The complete assembly mounts easily on pickup, dump and platform trucks CARBON STEEL MATERIAL HOPPER – Electrically welded 12-gauge ends and steel sides sloped at 45? are constructed with channel formed top edges 12-gauge vertical supports add extra strength to the unit The single lift point on the cross support beam is located at the unit’s center of gravity to allow for easy loading and unloading The floor is constructed of 10-gauge steel SD-1400100 Extended Chute – 96″ Spreaders – Body Side Length, 8′; Overall Length, 113″; Width, 47″; Height, 32 -1/2″ Recommended Use, 3/4 or 1-Ton Trucks CONVEYOR – The conveyor is made of 12″wide all-steel pintle chain with 3/16″x 3/4″cross bars Chain strength is 11,000 lbs.per strand;22,000 lbs. total weight Drive sprockets are 6-tooth cast iron, on a 1-1/8″ diameter shaft Conveyor chain has an adjustment range of 3-1/2″ Drive shaft has heavy-duty, sealed, self-aligning ball bearings with grease fittings Idler drum has heavy-duty 1″ diameter ball bearings CONVEYOR GEAR CASE – Gear is constructed of aluminum bronze, worm gear is hardened steel and ground Housing is made of durable cast iron Gear ratio is 20:1 with 1″ input shaft and 1-1/8″output shaft on tapered roller bearings SPINNER CHUTE ASSEMBLY – A polymer disc with four fins is connected to a 3/4″diameter shaft secured on two pillow block bearings The spreading material is guided from the conveyor to the spinner plate through an enclosed 12-gauge chute with internal and external deflectors Adjustable deflectors allow for complete directional spread control and full or compact spread Total spread radius ranges from 2’to 25′ The extra wide rear deflector protects the rear and under carriage of the vehicle FEEDGATE – Lever operated with a friction lock for accurate adjustment ENGINE – Heavy-duty 10.5 horsepower industrial/commercial Briggs & Stratton gasoline engine Engine comes equipped with alternator and 12 volt electric starter with in-cab start/stop and electric throttle control (standard) Entire engine is completely protected by the convenient hinged hood ELECTRIC THROTTLE CONTROL – Throttle control unit allows for full-range of throttle settings,including idle and full choke,via the in-cab hopper control box Use of electric throttle control eliminates cable freezing, binding and breaking CLUTCH – 12 volt DC electric clutch has a three-position in-cab switch, for greater control and material economy Also allows for low speed operation and spot spreading Available in the following sizes Item # Capacity Construction SD-1400250SS 1.5 cu.yds. Stainless Steel SD-1400100SS 2.0 cu.yds. Stainless Steel SD-1400100 2.0 cu.yds. Carbon Steel SD-1400350SS 2.5 cu.yds. Stainless Steel th, td { padding-right: 20px; } .product-table-top { display: block; max-width: -moz-fit-content; max-width: fit-content; overflow-x: auto; white-space: nowrap; }
