InPower s SAT-LDF20 Throttle provides high idle engine RPM control for vehicleswith an SEIC connector (F250-F550) directly. The SAT-LD has a blunt cut wireharness available if no SEIC connector is available for direct connect underthe hood connection to available wiring. The LDF20 control module connects tothe vehicle s SEIC connector. The cable also includes blunt-cut wires for theoperating mode inputs, RPM1, RPM2\Charge, and the speed adjustment whereas theSAT-LD has blunt cut wires for all interfaces. Fits 2020 Ford F250-F550 SEIC Throttle with Connector 2 RPM 12V Enable SAT-LDF20 Cable connects to SEIC connector on vehicles so equipped and the SAT-LD has a fully blunt-cut harness for vehicles without. Automatic charge protect and fixed speed modes. Customized functions are available. Operation of the two is identical, and the only differentiation is the harness. Low cost with fast and easy installation. Adjustable RPM Speed Settings. LED status and diagnostic indicators. Specifications +12 volts: Sourced from SEIC connector (SAT-LDF) or from fused Ignition source SAT-LD RPM1: +12 volts or ground as determined by software (see ordering guide) RPM2: +12 volts or ground as determined by software (see ordering guide) Ground: Sourced a Good Solid Battery Ground Speed Adjust Input: Adjusts preset RPM to desired value between 900 and 3000 RPM – (SEIC Max), (Chassis and Engine Dependent). Connect to +12V to increment, GND to decrement (50RPM/Sec). Dimensions: 3.17 L x 1.92 W x 0.79 H inches
